Hey guys, Wll I found out my clutch fork came loose because I broke the pivot ball in the case, My question is I am using an XTD stage 3 clutch form an NA Z32 and the throwout bearing looks way different than my stock one. I have just been using my stock on and it makes noise now so I might as well replace it while the tranny is out. Anyone know a throwout bearing from a different Nissan that will fit the rb20det tranny????
Need Help!! rb20 throwout bearing!!
Tim
1 - 6 of 6 Posts
Hey guys, Wll I found out my clutch fork came loose because I broke the pivot ball in the case, My question is I am using an XTD stage 3 clutch form an NA Z32 and the throwout bearing looks way different than my stock one. I have just been using my stock on and it makes noise now so I might as well replace it while the tranny is out. Anyone know a throwout bearing from a different Nissan that will fit the rb20det tranny????
Joined
·
508 Posts
http://www.240sxforums.com/forums//showthread.php?t=86573
KOYO bearing part # RCT40SA
that is currently what is riding in my car. I also had that same koyo bearing in my car for over a year and a half. Replaced it only because its cheap insurance and didn't want to take a chance of it failing later.
KOYO bearing part # RCT40SA
--Shwag
that is currently what is riding in my car. I also had that same koyo bearing in my car for over a year and a half. Replaced it only because its cheap insurance and didn't want to take a chance of it failing later.
Hey Ope,
I forgot you metioned that in your post, awesome!! Also, the rear main seal that you list the part # for, is that the engine rear main seal or the trans rear output shaft seal? My trans rear output shaft seal is also leaking a little, but I think that the KA seal should work as the KA driveshaft fits on the output shaft.
I forgot you metioned that in your post, awesome!! Also, the rear main seal that you list the part # for, is that the engine rear main seal or the trans rear output shaft seal? My trans rear output shaft seal is also leaking a little, but I think that the KA seal should work as the KA driveshaft fits on the output shaft.
1 - 6 of 6 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
