Nissan 240SX Forums banner
721 - 740 of 3,844 Posts
bought a chuki bumper, looked for a maf to replace my dead one, finished my de swap, finished making my exhaust, and removed parts from the parts car..




sounds mean as hell..i was still welding the hangers on in this pic, but with the solid motor mounts and tranny mount it didnt move at all when i started it..



everything is still a mess, but will be cleaned and organized good before its on the road again.

here's a short clip of the exhaust..and sorry about the crap quality, the pics and vid were taken on my phone..

http://s249.photobucket.com/albums/gg232/mirchris25/?action=view&current=12-09-07_1741.flv

http://s249.photobucket.com/albums/gg232/mirchris25/?action=view&current=12-09-07_1742.flv
 
in the same boat as you man........tell me if you fix it because im stumped on mine.....
I thought that you had decided that it was your heater core? Oh and I didn't do a damn thing to my 240 cuz its buried under 6 inches of snow.
 
ripped off ceiling parts and took out random shit to shave even more weight.

going to remove the tar mat from rear seats and back tomorrow. possibly take out the dash seats and carpet and put them in storage for a good month or two, going to remove the tar mat from front seats and forward along with re-routing the cabin wiring harness to make the interior look cleaner.
 
car wasnt heating up. put in a new thermo then it was overheating. found a leak in the thermo housing thing. fixed that with the gasket that napa said didnt exist. it was still overheating so i let it idle with the radiator cap off waited for the thermo to open and bleed the system of air. runs good now =]
 
i have no heat either :( i need to figure it out stat......is balls cold outside.

what i did to my 240 today: bought 120lbs of sand for the trunk and went drifting for hours on the snow :D
 
721 - 740 of 3,844 Posts