Nissan 240SX Forums banner
Cancel
Create thread New Garage Forums

autometer oil press unit wont fit.

SR20:
Jump to Latest
1 - 5 of 5 Posts
#2 ·
I ran a stainless steel line off of the block up to a mounting point behind the IM. I used a T fitting so I could connect the stock oil pressure sensor and the new sending unit. People also used to tell horror stories of the sending unit being so heavy it would snap off the block because the drilled hole isn't strong enough. I ran a T directly out of the block for a feed line on my integra, but I definitley wouldn't mount the huge sending unit directly into the block.
 
#3 ·
I actually just de-installed my oil presure gauge so I have my relocation line and T fitting sitting in the garage if you want to buy it from me. If you interested PM me and I'll give you a price. Its basically a 2 foot stainless steel oil line connected to a T fitting that is sized for the stock sensor and an aftermarket sending unit.
 
Discussion starter · #5 ·
duballstar said:
I actually just de-installed my oil presure gauge so I have my relocation line and T fitting sitting in the garage if you want to buy it from me. If you interested PM me and I'll give you a price. Its basically a 2 foot stainless steel oil line connected to a T fitting that is sized for the stock sensor and an aftermarket sending unit.
Click to expand...
pm'd : )
 
1 - 5 of 5 Posts
About this Discussion
4 Replies
2 Participants
Last post:
Andyc3020
Nissan 240SX Forums
posts
1.6M
members
94K
Since
2002
A forum community dedicated to Nissan 240SX owners and enthusiasts. Come join the discussion about performance, builds, engine swaps, turbos, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
S13 240SX (89-94) New Member Introductions General Tech S14 240SX (95-98) KA24DE & KA24E