Nissan 240SX Forums banner
1 - 20 of 23 Posts

240boosted

· Registered
Joined
·
73 Posts
Discussion starter · #1 ·
Hey well I new to the wholre "motor swap" i read that motor forum that was posted about the motors. I was wondering i was on jdmtiger looking at motors. Now i need a motor and transmission. Now when they sell the motors i was told For a complete motor swap i need Complete Block head RWD 5spd Transmission
ECU Ignitor Chip MAF Uncut Wiring Harness Turbo Coil Pack Intake Manifold Exhaust Manifold
Turbo Throttle Body Cam-Angle Sensor Alternator Starter Sensors Power Steering pump injectors. Is there anything else needed. I was told I woulde defentily need the wiring harnes and the ecu . With the car i was told the Timing Chain Problems Clutch is Spongy "Need Master Cylinder". I wanted to put rb25 motor in. Thanks guys
 
covered hundreds of times.. I refuse to do this yet again.

btw, shouldnt it be "When you buy a motor online" ?
 
Discussion starter · #5 ·
think I found it
Turbo manifold
Turbo
wastegate
down pipe
intercooler and brackets
intercooler piping
bov
fuel pump / regulator
some kinda engine management
oil lines
misc vaccmues lines
couplers and t-bolt clamps

basic turbo setup.
 
So its seems that hatin on the sr is common in these parts lol i have my build sheet for lsx in the s13 but i cant find a coupe in my area to get going on it lol.
 
1 - 20 of 23 Posts