Nissan 240SX Forums banner
21 - 29 of 29 Posts
Duct-tape will be all that is needed. I am jk but you could do that until you fill the holes. If you don't want to do it yourself call some local bodyshops and get a quote. I am sure it couldn't be much more or less then $100.
wouldnt recommend this. unless u really have too, u coudl just keep the wing on till u get the stuff to fill the holes. the tape would leave residue behind, but it can be sanded off. just dont leave them on while its raining. my dad did it on a accord n it just peeled off after a couple of days of raining.
 
wtf ppl.....its just some fuckin HOLES...

ffs go to advanced auto parts, ask for the fiberglass repair kit, (ITS $12-$15)

and do it yourself....itll take you an hour tops. Cut 4 (or whatever nuber of holes) small sqaures of the fiberglass cloth, 1inch by 1 inch, use the little popsickle stick to dip the square in the fuckin fiberglass resin, and PUT IT ON THE HOLE....

then let it dry and shit, bust out some friggen 400grit and lightly sand the area till its smooth and shit..

painting or touch up is another story, do whatever floats your raft!!!!!!!!!

Why is everything so difficult for you non-DIY!!!! :fireassau
 
Discussion starter · #25 ·
oh how am i going to paint it then after i fiberglass it
 
Discussion starter · #26 ·
wtfgfff 240's FB's look so good without a spoiler ...............
 
Discussion starter · #27 ·
ok i took off the spoiler again and just taped up the underside of it and just bondo'd it up...then i sanded with a 120 grit and wetsanded with 2000 grit....these were the only grits i had lying around,


now what primer should i use and what grit should i sand with before priming it??
 
Discussion starter · #28 · (Edited)
here are some pictures...i think the bondo turned out good...just need to spray paint it with primer now

BEFORE:




AFTER:



so what do you think guys?
 
21 - 29 of 29 Posts