Nissan 240SX Forums banner

1 - 10 of 10 Posts

·
Registered
Joined
·
2,903 Posts
Discussion Starter · #1 ·
so basically my crank/main bearing on cyl #4 decides to go to hell. and get shavings all over my motor. So now i have to tear that bitch apart. the question is>> Should i buy an engine stand and take about a year to build it replacing the whole bottom end with forged components and a headgasket or should i just put in pistons , crank/main bearings and a new headgasket and be done in about 3-4 months?? opinions? does anyone have any good prices on anything? here is a pic of the bearing that decided to be gay

 

·
Registered
Joined
·
273 Posts
if its not ur daily id put it on a stand and rebuild it the right way, make sure crank and caps and all are good. nice titties
 

·
Registered
Joined
·
1,061 Posts
I would just put good shit in it, Do it once do it right. Theres no point in spending the money and a few months down the road its gona get ripped part. Its like workin your self in a circle.
 

·
Registered
Joined
·
2,903 Posts
Discussion Starter · #5 ·
i need the help of S15drift king.. he is selling some rods i need to get my hands on
 

·
Registered
Joined
·
2,903 Posts
Discussion Starter · #8 ·
isnt KA-T .. mostly KA stuff?
 

·
Registered
Joined
·
2,903 Posts
Discussion Starter · #10 ·
send paypal donations to [email protected]

i`ll even put a sticker of your choice on my car

lol
 
1 - 10 of 10 Posts
Top