Nissan 240SX Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
396 Posts
For $245. I'd rather get the NISMO powerbar2 $200 from Jspec.com
With the $45 i'll save, i'd go buy 2 boxes of pizza, a case of beer, and a box of condoms.
 

·
Registered
Joined
·
70 Posts
Discussion Starter #3
Well as for as the power bar, why not just get a steel tubing and weld it directly to the existing tension rod bracket? Buy a squre tubing for $10 and weld it, and save $190 for some whore on the corner of a street.

So I would probably assume that these fender braces aren't that useful.
Forget the prices and budgeting. Im talking about these braces affectiveness.
 

·
Registered
Joined
·
24 Posts
nissanperformance mag did a review of these on a Z32 a while back and commented very highly of them.

I thought about building a few sets, but decided not to bother. fabrication costs would be too high to make much money on them in the quantities of parts I sell.

anyway, they are an effective mod, but whether it's worth $250 to you or not is your call.
 

·
Registered
Joined
·
70 Posts
Discussion Starter #7
stillen180sx said:
If your a fabricator why dont you weld together your own fender braces
No shit dude! *sarcastically*

Seriously, $250 for fender braces is over priced. If they are mass produced, pricing should be running the same as camber arms, $100 a pair.

Ill make a set this weekend, and Ill get back on this thread to tell you the result.
 
1 - 7 of 7 Posts
Top