Nissan 240SX Forums banner

front bumper for s13

1.3K views 13 replies 9 participants last post by  dousan  
#1 · (Edited)
I'm currently doing extensive at-home dent-repair and body work on my 92 hatch and have been tossing around the idea of installing a body kit.... i decided against this when i discovered the piston rings in my ka have gone bad (engine has 154k miles on it, was rebuilt by former owner, its very clean but apparently he forgot/was too lazy/was too retarded to replace some parts) so it looks like my sr20 swap is going to happen a little sooner than planned. seeing as how money has become tighter i'm not looking for a full bodykit, but i would like to find a front bumper that lowers the front end and looks good without sideskirts and rear bumper to match. any ideas?
 
#4 ·
dousan said:
its also low too. fiberglass lips arent cool. one goo drive way and BYE BYE LIP!

best bet!! OEM BABY!
89/90 SE lip ziptied onto the 91+ front bumper!!!!!! looks great and wont shatter upon impact
:werd
 
#12 ·
I agree with starbucks, the '89-90 lip looks ugly as hell on the '91-93 bumper...doesn't look right

Oh, and Dousan, "your" shows possession (example: That is YOUR 240sx.), while "you're" is a contraction for "you are" (example: YOU'RE not very good with grammar.).

;)