Nissan 240SX Forums banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,101 Posts
Discussion Starter · #1 ·
... do i get the plugs un plugged from the tranny? they are huge and its hard to find anything that resembles a release when you are laying under the car in a puddle of oil... any help? im about ready to clip them but thats a bad idea and very hack...
 

·
Registered
Joined
·
4,582 Posts
Which plug are you pulling out? I had a hard time with a few because they were covered in all kinds of crap.
 

·
Registered
Joined
·
1,101 Posts
Discussion Starter · #3 ·
its the 2 big ones on the trans. there is one on the top by the shifter and one about mid tranny. both on the pass side obviously. they are 2 wires but the plugs are massive. the wires are on brass somethings that screw into the trans if that helps
 

·
Registered
Joined
·
404 Posts
is this an automatic? If so I couldn't get the plugs out either. I just unplugged the wires at the other end and pulled the wires through the frame. that was the only solution I could come up with. Don't cut the wires, that looks like crap.
 

·
Registered
Joined
·
1,889 Posts
if theres no clip on the plug then follow the wire towards the motor there should be a plug.
 
1 - 5 of 5 Posts
Top