Nissan 240SX Forums banner

New header and now problems....

567 Views 1 Reply 2 Participants Last post by  unreal-
Ok i have an 95 240sx and i have a exhaust from the cat back and thats it....

Symptoms: Putting, Runs good at 3k rpm, anything else than 3k is just alot of backfire and bad acceleration.....


Ok so i got my header in today and got it on the egr valve wont line up right wit it so i left it alone and the oxy sensor is hooked in there but im missing one bolt on the header to downpipe connection and the egr isnt hooked in.....




Please help :/
1 - 2 of 2 Posts
1st problem: check your MAF, and clean it with CRC MAF cleaner.

2nd problem: mine didnt line up either (OBX) so i had the shop just weld it to the fitting on the header.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top