Nissan 240SX Forums banner
1 - 12 of 12 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter · #1 · (Edited)
so i just read this:
http://home.satx.rr.com/nissanweb/RadTest/RadTest.htm

and went and got a radiator fan assy. from the '95 altima mentioned in this write up! it cost me $80 w/tax but now that i got back to my house thinking it would fit my radiator i found that, infact, it won't...:(

ANY IDEAS?? neither of the mounting brackets line up to my radiator...i dunno
 

·
Registered
Joined
·
39 Posts
I used a duel flow all american drag radiator that did not fit until i made major modifications , Hail the mighty zip tie and 2"x 1/8" aluminum stock a square iron block and a BFH (Big f'n Hammer). and do it to it .
 

·
Registered
Joined
·
227 Posts
just makes sure the bottom is seated in and just ziptie the top 2 tabs, you might have to trim back some of the shroud, i had too anyway.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top