Check for spark and pull the fuel line and see if you get fuel when you turn the key on .

Sent from my SM-N975U using Tapatalk

 

I pulled the fuel line

I pulled the fuel line as you recommended and it is getting gas pass the filter.

 

Thank you. I will check for the spark when my spark tester arrives tomorrow. Exactly where do I pull the fuel line?

 

I'm having the same issue I checked spark a
good and fuel I didn't see any but it smelt like fuel and cylinder 4 had a brown spot from trying to fire. It had 60 compression across the board but it should still sputter even tho it'll run like crap. I also checked the dizzy and good. Can a alternator can make it not fire?

 

I put in a ecu and it has a light now this is an obd1 91 s13 manual btw

 

Just did a spark test and not getting anything.

 

Could be distributor a or plug wires. I checked spark and I had spark.

 

You need to fine a distributor wiring diagram and see if the distributor is getting power and it may be a bad crank sensor

Sent from my SM-N975U using Tapatalk

 

I've had this a few times before on a KA24de-t. Have you tried unplugging the wire harness from the injectors and cranking it over?

 

Also, how is your throttle plate set?